Call me crazy, but I have had no trouble with flooding since day one.  That is probably because I always shut the engine down by turning off the fuel pump.

The original engine I bought for education was declared inop by its previous owner.  Turns out it was only flooded (due to leaky injectors).  I read about the problem and the fix like y'all are doing, but killing the pressure at shutdown seemed simpler to me.

-- Bill Eslick
www.weslick.com


On 5/4/06, Mark R Steitle <mark.steitle@austin.utexas.edu> wrote:
Ben,

I tapped the ID of a Tee fitting to accept the motorcycle carb jet.  Then I screwed the jet into the threaded hole with some Lock-tite to keep it in place.


Mark


From: Rotary motors in aircraft [mailto: flyrotary@lancaironline.net] On Behalf Of Ben Schneider
Sent: Wednesday, May 03, 2006 6:23 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Fuel system pressure bleed off


Group...
   I am installing my fuel system on my Renesis right now. I seem to remember (correct me if I am wrong)  that the consensus was to use a .020 orfice bypass of the regulator to bleed off the pressure in the event of pump prime loss.
My question is, how exactly are some of you going about this? Are you welding an AN fitting shut, then drilling it out to .020? Is there something of this nature commercially available?  Suggestions?  I have only to run the fuel lines, then wire the engine, a few other little misc. items, and I should be ready for first engine start.

Ben Schneider   N713R   RV7 Renesis