|
Here are three photos of the cowl
progress. The bump on the top is for the Weber 48. The two bumps on
the lower cowl are for the ends of the oil cooler and the last picture is
the mold for the oil cooler diffuser and the mold in progress for the air inlet
for the oil cooler. The diffuser was shaped by taping foam on the oil
cooler and the inlet, then placing 1 inch pieces in between and carving with
sharp knife, then a slight covering with drywall mud. If there is a
simpler way, let us all know, as it is all a learning experience for me.
JohnD
|