|
|
Hi Buly,
I haven't tried to take it apart yet, but I also used the gray
sealant. I also, per Tracy's recommendation, put a light coat of oil
on one of the surfaces before pressing on the other side with the
sealant. That's supposed to release easier and not cause any leak
problems. I haven't had a leak problem in 1.3 hours running time on
the engine.
Bob W.
On Wed, 1 Feb 2006 18:56:52 -0500
Bulent Aliev <atlasyts@bellsouth.net> wrote:
I received my updated driveshaft today. Thank you Tracy. Now, what's the latest on the gear box assembly sealant. Last time I used the recommended Permatex Super Gray and I could have welded it with the same results :) It was a bear to split it from the mounting plate. Did anybody come with anything better, or I just have to go the same route? Thanks.
BTW I like this new "double stack" thrust bearing.
Bulent "Buly" Aliev
http://tinyurl.com/dcy36
--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (first engine start 1/7/06)
Custom Cables for your rotary installation -
http://www.roblinphoto.com/shop/
|
|