Received-SPF: pass
 receiver=logan.com; client-ip=64.136.22.78; envelope-from=jbker@juno.com
To: flyrotary@lancaironline.net
Date: Thu, 12 Jan 2006 07:15:27 -0500
Subject: Re: [FlyRotary] Re: Momentary pucker X's 3
Message-ID: <20060112.071528.936.8.JBKER@juno.com>
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit
From: WALTER B KERR <jbker@juno.com>

Duane,
Will call Tracy this AM, but mine is pinned I think, so hard to imagine
it slipped.

Bernie
==========================

On Wed, 11 Jan 2006 21:49:12 -0500 (GMT-05:00) Duane Service
<duaneservice@earthlink.net> writes:
> Just a lurker here, but could it have been the shaft in the psru, 
> slipping and rewelding, as just stated on the threads?  Duane 
> Service, Florida
> 
> -----Original Message-----
> >From: Charlie England <ceengland@bellsouth.net>
> >Sent: Jan 11, 2006 6:08 PM
> >To: Rotary motors in aircraft <flyrotary@lancaironline.net>
> >Subject: [FlyRotary] Re: Momentary pucker X's 3
> >
> >WALTER B KERR wrote:
> >
> >>Flying around the neighborhood today and about 30 minutes into 
> flight
> >>there was a momentary hic-up. Everything on monitor looked normal, 
> so
> >>richened a tad and continued flying. About 5 minutes later, same 
> thing
> >>second verse, and then a third time. Went to full power and rich 
> and it
> >>did not repeat. No miss while descending to land or while taxing 
> in. Ran
> >>up a full static for a minute on the ground and everything 
> appeared
> >>normal.
> >>
> >>Any suggestions???
> >>
> >>Bernie, not wanting to start to Lakeland with an unknow problem!
> >>  
> >>
> >
> >Nothing constructive to offer, but is there a Lyc part hiding under 
> the 
> >cowl somewhere?
> >
> >
> >--
> >Homepage:  http://www.flyrotary.com/
> >Archive and UnSub:   
> http://mail.lancaironline.net/lists/flyrotary/
> 
> 
> --
> Homepage:  http://www.flyrotary.com/
> Archive and UnSub:   http://mail.lancaironline.net/lists/flyrotary/
> 
>