|
George,
I cannot use Autocad but I am sure someone in the group here in the states
can take it and come up with a scale drawing guys like me can use !!
Thanks George,
--
Kelly Troyer
Dyke Delta/13B/RD1C/EC2
-------------- Original message from "george lendich" <lendich@optusnet.com.au>: --------------
Kelly/ Tracy,
I have that on AutoCAD 4 if you need it.
It would need to be modified ( perhaps) if used on another set-up, as the bottom bolt hole is off-set, so as you don't inadvertently put it around the wrong way (on the RX8).
Unless they do that with some RX7 components as well - it's a good safety point.
George
----- Original Message -----
Sent: Saturday, December 03, 2005 3:21 PM
Subject: [FlyRotary] Re: Renisis Timing Plate
No, but they look very easy to copy. I can gen-up a drawing if needed.
Tracy
----- Original Message -----
Sent: Friday, December 02, 2005 2:07 PM
Subject: [FlyRotary] Renisis Timing Plate
Tracy,
Have you been able to source the Renisis ignition timing plate
without the complete hub assembly ?? I need one !!
--
Kelly Troyer
Dyke Delta/13B/RD1C/EC2
|