|
Kelly/ Tracy,
I have that on AutoCAD 4 if you need it.
It would need to be modified ( perhaps) if used on another
set-up, as the bottom bolt hole is off-set, so as you don't inadvertently put it
around the wrong way (on the RX8).
Unless they do that with some RX7 components as well -
it's a good safety point.
George
----- Original Message -----
Sent: Saturday, December 03, 2005 3:21
PM
Subject: [FlyRotary] Re: Renisis Timing
Plate
No, but they look very easy to copy. I can gen-up a drawing
if needed.
Tracy
----- Original Message -----
Sent: Friday, December 02, 2005 2:07
PM
Subject: [FlyRotary] Renisis Timing
Plate
Tracy,
Have you been able to source the Renisis ignition
timing plate
without the complete hub assembly ?? I need one !!
--
Kelly Troyer
Dyke
Delta/13B/RD1C/EC2
|