-----
Original Message -----
Sent:
Friday, April 01, 2005 5:25 PM
Subject:
[FlyRotary] Re: Well, I bought an RX-8 Engine....
Dave and All,
I couldn't find that area on
Tracy's site and as the Series 6 has tapered bearing on the stationary
gears, I'm wondering of the RX8 has gone that way also.
Secondly, what again, is Tracy's
modification for the thermal pellet - I'm wondering if I can do
without the thermal pellet completely.
George ( down under)
I do not know the compatibilities between year models for
the starters across the RX line...
To use Tracy's RD-1 Series PSRU's, you need the 86-91 auto tranny flex
plate, and the starter is from the 86-91 Manual trans, normally
aspirated, engine. You may check with a parts house to see how many
different choices there really are.. but if it will fir the 91 NA MT,
it will fit the RD.
Double check with Tracy, but I believe the same eccentric shaft is used
in the RX-8 (according to tracy's travails on his webpage at www.rotaryaviation.com
(what's new section). So.. same eshaft means same thermal pellet.
Dave
Bill Dube wrote:
- I believe you will need a starter
- from an RX-7 engine to use with Tracy's RD -1C.
Is this so? What year(s)? Is the auto starter different from the
manual?
Does the RX-7 thermal pellet plug work, or is the RX-8 different?
Thanks again, in advance :^)
(Note non-bouncing emoticon above)
>> Homepage: http://www.flyrotary.com/
>> Archive: http://lancaironline.net/lists/flyrotary/List.html
>> Homepage: http://www.flyrotary.com/
>> Archive: http://lancaironline.net/lists/flyrotary/List.html