|
-it looks like if you had used the
muffler where the inlet is on the edge rather than the middle, and didn't
attempt to have the muffler perfectly down the center, that you could eliminate
an elbow. I'm not being critical of what you have, you do beautiful work,
just throwing out an idea since you haven't finish welded things yet.
Isn't it surprising how much those mufflers weigh? It appears you have the
same one I am going to use, except I have 3 rotors! Wonder how long it
will last? My welder warned me that after the exhaust is coated inside and
out that it is very difficult to repair any cracks. So I have decided to
wait before any jet-coating gets done. Nice flanges, they look
familiar!
----- Original Message -----
Sent: Wednesday, March 23, 2005 1:51
PM
Subject: [FlyRotary] Exhaust System
Charlie,
Here are some photos of my exhaust setup using a
Spintech muffler, and a 2 into 1 adapter. Tough to get it down between the
motor mounts, etc. Still have to have it finished welded and put retainer tabs
on the joints, although I don't think anything can go anywhere.
Have you obtained an engine yet?
Bill Schertz
KIS Cruiser # 4045
>> Homepage:
http://www.flyrotary.com/
>> Archive:
http://lancaironline.net/lists/flyrotary/List.html
|