|
|
Hi Kevin;
My exhaust didn't work out exactly as I'd envisioned it and as a
result the pipe is almost touching 2 of my mount struts where it passes
between them. I was quite concerned about heat damaging the mount, so I
kept a very close eye on this area. However it really hasn't been an
issue. The paint on the mount hasn't discoloured at all so I haven't
been too concerned, however I still check it often. When I first
received the EM2, I attached one of my spare CHT thermocouples to the
mount to monitor it and while I can't recall the temp, I know it was low
enough that I stopped worrying about it. I should've logged it.
Todd this is a good point and I admit to have not thought it through yet. I
have made two engine mount plates so far because the first one had the
exhaust almost touching the exhaust, maybe 1/8" clearance. I will have
to come up with some type of shield however. I hope, also, to introduce
some fresh air flow over them also.
Kevin Lane Portland, OR
I'm curious if you're planning some kind of heat shield for that mount
strut that runs between the exhaust pipes... or maybe several layers
of exhaust tape... something to keep some of that heat away anyhow?
Looks scary to me, especially when you consider that those exhaust tubes
will likely be glowing red at full throttle. Just a thought.
<Marv>
|
|