|
|
Hi Jim,
When I searched for XRP, I actually ended up at DragParts.com. xrp.com says "comming soon". I was just curious where you actually bought your adapters.
Bob White
On Fri, 18 Feb 2005 13:40:53 -0600
Jim Sower <canarder@frontiernet.net> wrote:
<... can drill them out to at least the ID of the 5/16 inch hose barb ...>
That's exactly what I did. The drill turned out to be 1/64" smaller than the 1/4" I was shooting for, but I figure if works for Tracy, it'll work for me. I could drill it out to 1/4" or even a tad bigger if I thought I really needed it, but then I'd be worried about structural integrity.
Jim S.
--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)
|
|