There was a lot of chat a few
weeks ago about “current draw”. For amps readout on the EM2, I have a
little circuit board that I had made that will give a 0-5 volt output signal
from the standard 0-50 mv output from an ammeter shunt. (See http://www.bandc.biz/cgi-bin/ez-catalog/cat_display.cgi?15X358218
). Feed the output to an unused channel on the EM2 and have current
readout.
I had three made to keep the
unit cost down, and I’m willing to part with at least one. Contact me
off list at alventures@cox.net if
you’re interested.
Should work on a 0-5v channel,
and I tried to use the “right tank” channel, but it won’t take a voltage
signal. I’m still waiting for an answer from Tracy on
what it is that channel is set up for.
Al