flyrotary@lancaironline.net Mailing List Archive

Kelly, its either 3 1/4" or 4 1/4" can't recall off the top of my head (but, I think its 3 1/4") - but I do recall it was 1/4" thicker than my 68x72 performance prop so I was able to use the same prop bolts. I'll check when I go out to the airport tomorrow.

----- Original Message -----

From: Kelly Troyer

To: Rotary motors in aircraft

Sent: Monday, November 29, 2004 1:53 PM

Subject: [FlyRotary] Monster Prop Hub

Ed and Rusty,

What is the hub thickness of your 2.85 drive "Monster Props" ? I

would like to know what length of bolts are needed for this prop

including the crush plate,spinner back plate,etc .

Thanks,

--
Kelly Troyer
Dyke Delta/13B/RD1C/EC2