Return-Path: Received: from mail.tsisp.com ([65.23.108.44] verified) by logan.com (CommuniGate Pro SMTP 4.2) with ESMTP-TLS id 383273 for flyrotary@lancaironline.net; Sun, 29 Aug 2004 07:51:00 -0400 Received-SPF: none receiver=logan.com; client-ip=65.23.108.44; envelope-from=steve@tsisp.com Received: from stevehome by mail.tsisp.com (Technical Support Inc.) with SMTP id CQA74584 for ; Sun, 29 Aug 2004 07:50:27 -0400 Reply-To: From: "Steve Brooks" To: "'Rotary motors in aircraft'" Subject: RE: [FlyRotary] Engine run - Good news/bad news Date: Sun, 29 Aug 2004 07:51:56 -0400 Message-ID: <005401c48dbe$967b1d50$6400a8c0@WORKGROUP.local> MIME-Version: 1.0 Content-Type: multipart/alternative; boundary="----=_NextPart_000_0055_01C48D9D.0F697D50" X-Priority: 3 (Normal) X-MSMail-Priority: Normal X-Mailer: Microsoft Outlook CWS, Build 9.0.2416 (9.0.2910.0) X-MimeOLE: Produced By Microsoft MimeOLE V6.00.2800.1165 In-Reply-To: Importance: Normal This is a multi-part message in MIME format. ------=_NextPart_000_0055_01C48D9D.0F697D50 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Tried to check the O2 sensor output using a flame from a propane torch. Nothing. I'll probably try again to get a voltage reading at the sensor when I can run again. It still gives close to full scale reading no matter what mixture setting. Al, It takes a while for the O2 sensor to put out a reliable reading. I don't get a stable reading on mine until about 1-1/2 to 2 minutes. You will probably get some sort of reading after a few seconds, but I wouldn't put much faith in its' accuracy. Mine shows a very, very lean mixture while warming up. Regards, Steve ------=_NextPart_000_0055_01C48D9D.0F697D50 Content-Type: text/html; charset="us-ascii" Content-Transfer-Encoding: quoted-printable

Tried to check the O2 sensor output using a flame from a propane torch.  Nothing.  I’ll probably try again to get a voltage reading at = the sensor when I can run again.  It still gives close to full scale reading = no matter what mixture setting.<= /p>

 

Al= ,

It= takes a while for the O2 sensor to put out a reliable reading.  I don’t get a stable = reading on mine until about 1-1/2 to 2 minutes.  You will probably get some sort of reading after a few seconds, = but I wouldn’t put much faith in its’ accuracy.  Mine shows a very, very lean mixture while warming = up.

 

Re= gards,

St= eve

 <= /font><= /p>

------=_NextPart_000_0055_01C48D9D.0F697D50--