|
I swore I was just going to sit on my hands but.... darn-it I can't.
Bob your saying your more comfortable in a fighter [which has known for its SUPER POOR stall recovery ability] in slow flight than you are in the IV? I can't comment on the F22 as I never learned much about what it can or can't do in the stall. I can imagine w/ the vectored thrust that it's never going to be an issue unless your dead stick [at which time the plane would have to fend for itself while you pulled the 'handle', I'm sure] but the F16 has been known [since it was built] that it has NEARLY
unrecoverble in a stall. If you hit 10000' and your not recovered, just pull the handle. I've read accounts of test pilots who stalled them and it took 15000+ft to recover and then just barely before the hard-deck. As I understand it, to recover you need to use stick movement in the direction of the oscillations [rocking the plane in pitch to get it to 'unstall' at the apex of one of the down pitch oscillations]. So it's established, the F16 is not one to be stalled, infact I think there is a 'down pitch' command [built into the control software for the flight controls] that comes into play if the plane gets too slow. The only way to actually stall the airframe is to override that 'down pitch command'.
So your ok flying in slow flight w/ that type of plane but not in a IV, doesn't that speak to the need for more testing of the airframe to 'get comfortable'? I have no doubts in your skills, zero. You are as good a qualified pilot as we're going to find for the 'hands on, non-straight/level' stuff yet you don't want to explore the lower end of the envelope on the plane you carry family members in. Granted the IV doesn't have a 'seat' but it could have a spin chute! I understand that the F16's and 22's have had extensive test flying and their pilots extensive training and this is why their pilots are ok w/ slow flight, this is exactly what the IV needs [and the 300 series also] to 'tame' them.
Also it was mentioned about the F86 demonstration.... All I can say is 'exactly', he stayed inside the envelope, he also knew where the envelope was, what the limitations w/ the airframe were and where he could push it and where he couldn't. He was also flying an airframe that was well tested and it's deficency's known. He obviously was also a very skilled pilot. Would a person DARE try this in a Lancair? I'd hope not. That said, if you knew the airframe inside and out and it's limitations and how it behaved [was tamed??] in extreeme edges of the envelope then maybe a person skilled enough could do something similar [no that's not an endorsement on my part to try it in any form].
Bob Hoover showed a similar type of flying w/ his Shrike Commander back in the day in a plane that was never intended to be flown thus. The bottom line of all this [as I see it] is the 'amazing' flying that has been discussed always occurs in an airframe that is well tested and adjusted, by skilled pilots who are well trained. If we were to apply those same criteria to the IV and 300's [ok lets just say 'Lancairs'] then there could/would be the same level of confidence in those airframes also.
Ok onto another endless topic... FORD or Chevy? [a topic as likely to be solved as this 'To Stall or Not to Stall' topic :) ] [or how about MAC or PC?]
Jarrett Johnson [ok back to sitting on my hand again..]
235/320 55% and holding
> Pile on to the fighter comment:
>
> I flew F16s for 18 years and now fly the F-22. Both of those
> planes are easier to land than my IV-P. I have flown a lot of
> slow speed stuff in those planes, and I don't Intend to explore
> the stall characteristics of my plane, ever. If you are learning
> to fly, then yes, do so in a plane than can stall and was designed
> for it. Do all of that, get 1000 hours, and THEN get a IV-P, and
> quality training on how to fly it. Personally I get weary of the
> repeated " You need to see how it stalls if it ever happens"
> attitude. If you stay ahead of the airplane and don't take it
> where it doesn't need to be, you will never be there. It's never
> going to happen in this plane unless it's unintentional, and
> unless you are 10,000' up you are going to hit the ground and it
> isn't going to be pretty- period! The IV-P was designed to fly
> fast and efficient over long distance. Not to do acrobatics,
> stalls, anything else. It doesn't need to be fixed, it does
> exactly what it was intended to do! And pilots who wanna fix the
> IV-P or stall it should fly something else ( in my opinion).
>
> Bob R
>
>
>
> On Jun 24, 2011, at 10:02 PM, John Hafen <j.hafen@comcast.net> wrote:
>
> > One has to choose between stall strips and a heated leading edge.
> >
> > For me personally, stall strips would be more applicable for my
> Cub, which doesn't need them at all. And I have been in
> inadvertent icing conditions in the IVP and watched the ice curl
> up like potato chips and blow away. I'll keep the heated leading
> edge, thank you, rather than a stall strip that I would never use.
> >
> > And as far as a larger tail???
> > A. Who is going to spend the additional money to make their
> IVP look stupid?
> > B. The IVP is tail heavy already -- no one wants to load
> extra weight aft of the CG.
> > C. Challenged pilots should perhaps fly a different plane.
> >
> > I love the IVP the way it is. I have never crashed and died. I
> understand the envelope, and like it;)
> >
> > John
> >
> > (On military pilots and "training" to fly unstable air craft --
> I don't think you are accurate on this one. The F-16 is so
> unstable that it requires 20+ inputs per second to maintain
> straight and level flight. It is computerized. No human being on
> earth, no matter how highly trained, can manually fly an F-16
> straight and level. The "fly by wire" F-16 is way easier to fly
> than my IVP. The original side stick didn't move at all, but
> responded to pressure. Pilots hated it so it was redesigned to
> move slightly. And the pilots wishes to go a computer that
> controls the flight surfaces. There is no direct manual
> connection from the stick to the flight control surfaces. Even in
> the old F4, the flight control "feel" was artificial -- based on
> springs, as the hydraulic system supplied 3,000 psi to the flight
> control surfaces, which came in really handy over about mach 1.1.
> You don't need a million dollars worth of training to fly a IVP
> safely. HPAT, yes.)
> >
> > On Jun 24, 2011, at 11:24 AM, Wolfgang wrote:
> >
> > Military aircraft are unstable to allow better agility.
> > Military pilots get over a million dollars worth of training
> each to be able to handle their "unstable" aircraft.
> >
> > I don't see that happening for IVP drivers.
> >
> > There are a couple of things that can be done that don't
> adversely affect performance or handling.
> > Stall strips and larger tail feathers come to mind.
> >
> > Wolfgang
> >
> > From: John Hafen <j.hafen@comcast.net>
> > Sender: <marv@lancaironline.net>
> > Subject: Airplane needs to be "fixed," Stall Speeds, Wing Cuffs,
> Vortex Generators for L...
> > Date: Fri, 24 Jun 2011 06:05:59 -0400
> > To: lml@lancaironline.net
> > Wolfgang states: "If the airframe can't get back in the
> envelope, then the airframe needs to be fixed."
> >
> > There are lots of historical examples to the contrary, like the
> F4 Phantom. Once in a flat spin, the plane was unrecoverable from
> any altitude. "Stick Forward, Ailerons and Rudder Neutral, If not
> Recovered, Maintain Full Forward Stick and Deploy Drag Shoot" were
> not enough.
> >
> > Yet the F4 was the work horse fighter for the Navy, Air Force,
> Marines, and hosts of allies for decades. And it was fast, over
> Mach II.
> >
> > Yet, you stayed far far away from "departing" -- high angle of
> attack, stick one way and the rudder the other.....
> >
> > Most advanced stalls in IVP are recoverable, given 10,000 feet
> or so.
> >
> > But unlike the F4, most of our IVPs are not equipped with Martin-
> Baker ejection seats.
> >
> > The F4 never got fixed. The IVP got "fixed." It's called the
> "ES," with larger differently shaped wings and fixed gear, that
> became the Columbia/Cessna.
> >
> > The "fix" was a series of tradeoffs that IMHO made it a less
> desirable plane -- slower, fixed gear, non-pressurized.
> >
> > I'll happily keep the un-fixed version of the IVP myself, thank
> you.
> >
> > John Hafen
> >
> >
> >
> >
> > On Jun 23, 2011, at 9:11 AM, Wolfgang wrote:
> >
> > I, for one, want to be able to recover from an "adverse"
> condition should I ever find myself in one.
> > Knowing where the edges of the envelope are and how to get beck
> in the envelope should be required.
> > If the airframe can't get back in the envelope, then the
> airframe needs to be fixed.
> >
> > Wolfgang
> > ----- Original Message -----
> > From: Karen Farnsworth
> > To: lml@lancaironline.net
> > Sent: Wednesday, June 22, 2011 2:12 PM
> > Subject: RE: [LML] Re: Stall Speeds, Wing Cuffs, Vortex
> Generators for L...
> >
> > David,
> >
> >
> > I have no problem with anyone who wants to explore the
> “envelope” of his/her airplane. However, I take great exception to
> you grounding me because I might choose to not get as near to the
> edge as you.
> >
> >
> > Lynn Farnsworth
> >
> > Super Legacy #235
> >
> > TSIO-550 Powered
> >
> > Reno Race #44
> >
> > Mmo .6
> >
> >
> > I agree 100% also.
> >
> > If you don’t know what the incipient stall feels like in the
> stick and the airframe you should not be flying the Legacy or
> 320’s.
> >
> > (Not knowing this is the single biggest killer of Lancair pilots.)
> >
> >
> > David T.
> >
> > Legacy
> >
> >
> >
>
|