<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
          <<  Lancair Builders' Mail List  >>
          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
>>
Rob Wolf,
I experienced the same problem that you mentioned.  I did basically what you
are suggesting.  I recessed the puck into the BL51 rib and did a 3 bid
lay-up on the inside of the tank to provide mounting and support for the
probe.  Also, filled in around the recess with epoxy  flox for rigidity to
the outer skin.  For access to the adjustment screws on the puck, I made an
oval shaped hole, about 3/4  x 1 1/4 inch in the BL-50 rib.  This hole has
to be big enough so that you can see the adjustment screws from the gear
well.  If not, it would be very difficult to find them in the blind with the
end of a screw driver.
Bob Jude


>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML website:   http://www.olsusa.com/Users/Mkaye/maillist.html
LML Builders' Bookstore:   http://www.buildersbooks.com/lancair

Please send your photos and drawings to marvkaye@olsusa.com.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>