Sender: <marv@lancaironline.net>
To:  lml@lancaironline.net
Date: Sat, 10 Aug 2013 08:58:35 -0400
Message-ID: <redirect-6412118@logan.com>
Received-SPF: none
 receiver=logan.com; client-ip=98.138.91.235; envelope-from=jcollins@snet.net
Subject: Re: [LML] Re: Header Tank
References: <list-6411820@logan.com>
From: James Collins <jcollins@snet.net>
Content-Type: text/plain;
	charset=us-ascii
In-Reply-To: <list-6411820@logan.com>
Content-Transfer-Encoding: quoted-printable
Mime-Version: 1.0 (1.0)

Thanks again Bill. Very good pictures

=46rom Jim Collins iPad=20


On Aug 10, 2013, at 12:02 AM, "Bill Harrelson" <n5zq@verizon.net> wrote:

> Jim,
>=20
> Here are photos of the sight gauge on the 320 and the IV. Basically done t=
he same. On the 320 I covered the AN842 with micro and shaped it. On the IV I=
 left it exposed. Actually, I like the exposed version better.
>=20
> Bill Harrelson
> N5ZQ 320 2,150 hrs
> N6ZQ  IV  350 hrs
>=20
>=20
>=20
>=20
>=20
> Thanks Bill. Any pictures?
>=20
> =46rom Jim Collins iPad
>=20
>=20
>=20
>=20
>=20
>=20
>=20
>=20
> On Aug 6, 2013, at 11:42 AM, "Bill Harrelson" <n5zq@verizon.net> wrote:
>=20
>> Jim,
>>=20
>> A sight gauge is an excellent accompaniment to a header tank. There are, o=
f course, many ways to fabricate the gauge. My choice is to use clear PVC tu=
bing (Spruce p/n 03-54100). You tap the ends to accept AN842 90 degree fitti=
ngs. Drill two holes in the panel to accept the hose end of the 842s. Insert=
 rubber grommets in the holes. push the fittings through the grommets. Put a=
 hose clamp over the hose on the back side of the panel which will secure th=
e hose to the fitting as well as hold the sight gauge to the panel. On our I=
V we also put a 3 sided square channel around the tube for protection from a=
ccidental bumps.
>>=20
>> Bill Harrelson
>> N5ZQ  320 2,150 hrs
>> N6ZQ  IV  350 hrs
> <DSCF7843.JPG>
> <DSCF7848.JPG>
> --
> For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.htm=
l