lml@lancaironline.net Mailing List Archive

JPI bought out VM.

Bruce
WWW.Glasair.org

-----Original Message-----
From: Lancair Mailing List [mailto:lml@lancaironline.net] On Behalf Of William A. Hogarty
Sent: Monday, May 13, 2013 12:32 PM
To: Lancair Mailing List
Subject: [LML] Re: Electronics International divide-by-4 (/4)

Does anyone know a method to test a VM probe in the wing when the wing has been removed from the ,plane.

Also, assuming the probe is faulty, where to find a replacement????

Thanks, Bill Hogarty

On Mon, May 13, 2013 at 4:50 AM, Greenbacks, UnLtd. <N4ZQ@verizon.net> wrote:

Danny, their /4 changes the base sensor count before calibration and depending on the length of your probes, there should be no need to install this device between the probe and FLC.
I have 2 4' Vision Micro Systems probes in my wings and they interface seamlessly with my EI MVP-50. Their /4 device is
required in line when the probe is short as in my header tank...16".

Angier Ames
N4ZQ
--
For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.html