I am finally done painting the thing, so I can move to new challenges.

 

I am working on the firewall now and would like to get all holes just about right the first time.

I am installing a JPI EDM930 engine monitor (very similar to VM1000C), and need to route fifty-some tiny wires through the firewall. I bought a couple of 16 pin Amphenol connectors a an early stage, but this is clearly not enough. I also have some concerns about cutting and soldering all those wires, as this surely introduces yet fifty-some new possible sources of failure. Most of the wires are also shielded and what have we all.......

 

I lean towards making one large harness that simply runs thrugh the firewall in one or two bundles and just live with the trouble if I ever need to take of the engine.

 

What did you guys do and how did you make it look awardwinning nice and yet fireproof???

 

Photos GREATLY appreciated!

 

Regards

Tim Jorgensen

360 Gamma (MKIIFBOB, 90%)