Mailing List lml@lancaironline.net Message #48152
From: <marv@lancair.net>
Subject: Re: IV-P Non over-center links
Date: Sun, 27 Jul 2008 21:40:09 -0400
To: <lml>

Posted for "Mick Guinn" <rightseatmech@bendbroadband.com>:

 Has anybody seen this? It's a nose gear over-center link that does not go
over-center.
 If you notice in the attached picture, the three pivot points of the lower
assembly (older unit) are in alignment, resulting in a poor to non-existent
over-center condition. The white (newer unit) scissor link assembly has an
obvious over-center condition by approximately 3/4". The bottom assembly was
removed from an older kit and since then, I've found a second 'non-over-center
link' assembly on another, older kit.
 Might be a good idea to take a quick look and see if those three bolts line
up on your IV-P. Could save you a lot of grief.
 
 Mick Guinn
 Rightseatmech.com
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster