|
For what it's worth, I've used this same model crimper (it's from Paladin)
on several panel projects. I have two die sets for it. One
(#2092) works well on 0.062" and 0.093" Molex pins/sockets as well as
the pins/sockets used in Amp CPCs. The other die (which doesn't seem
to have a number on it) works nicely for BNC and TNC coax
connectors. They also have a die for insulated terminals but I don't use
it as I already had a crimper that works better for PIDG
insulated terminals. I've gotten very good service from it and good
quality crimps.
Tom Gourley
----- Original Message -----
Sent: Tuesday, April 22, 2008 10:39
PM
Subject: [LML] Re: MAC servo wire
connections
I found this product back when I was shopping for crimpers. It's
served me well throughout my project. The interchangeable dies allow
quick change between just about any crimp requirement.
Mike Easley
Colorado Springs
Need a new ride? Check out the largest site for U.S. used car listings at AOL
Autos.
|