|
Has anyone had a problem with their
VisionMicro 1000 MAP sensor? Mine is reading very very slow. It's solid and I
checked all the wiring. I connected a vacuum pump to it today and when I run the
pressure down the VM 1000 will start to read lower and lower but it takes about
10 seconds for it to change a very small amount. EX: from 27 to 10 might take 4
~ 5 minutes, and back again the same.
It seems like the MAP sensor is reading
right but takes forever to change... Anyone see this, or fixed the same
problem?
Thanks,
Randy Stuart
LNC2
|