Return-Path: Received: from smtp3.gateway.net ([208.230.117.247]) by truman.olsusa.com (Post.Office MTA v3.5.1 release 219 ID# 0-52269U2500L250S0V35) with ESMTP id com for ; Mon, 15 Nov 1999 04:02:25 -0500 Received: from oemcomputer (1Cust28.tnt1.coeur-dalene.id.da.uu.net [63.27.107.28]) by smtp3.gateway.net (8.9.3/8.9.3) with SMTP id EAA20163 for ; Mon, 15 Nov 1999 04:06:48 -0500 (EST) Message-ID: <000901bf2f49$14550ee0$1c6b1b3f@oemcomputer> Reply-To: "dfs" From: "dfs" To: "Lancair List" Subject: Go around procedures Date: Mon, 15 Nov 1999 01:09:09 -0800 X-Mailing-List: lancair.list@olsusa.com Mime-Version: 1.0 <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> << Lancair Builders' Mail List >> <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> >> Before I commit my go-around procedure to bytes, let me first second Dave Morss' note that (paraphrased) every Lancair is different and even the one you fly all the time will handle differently depending on loading, CG, pilot technique, familiarity with the field, etc. So, that out of the way, I used to fly mine in and out of the Long Beach, Ca airport when I lived down in LALA land and with a lay-out that resembled a huge Tic-Tac-Toe game plus commercial heavy iron operating there on the long diagonal runway, one had to have a go-around in mind on every approach. Did a bunch of them, too! Mine was pretty straight forward: First, power up (and with an electric MT prop, this had to be done gently to avoid over-speed as they are somewhat slow to react - of course, the prop is already set to flat pitch or high RPM during the approach to the field). When you bring in the power, you must keep the ball centered with the rudder - don't just step on the pedal - over correction is just as bad as none - at the speed you will be at just before landing, coordination is to be strived for. Almost simultaneously, apply back pressure to arrest sink as the power comes in and immediately after, flaps up in a couple of steps just being sure not to let the airplane start sinking again (I have a stop at zero flaps or neutral, whatever you like to call it so I don't have to worry about going back into reflex - which would probably kill a bunch of lift just when it's needed most). Once I'm absolutely sure I'm flying level or have a positive climb rate (at least not still sinking) I then retract the gear. Remember, your gear is hanging out during a normal take-off so the airplane will fly and climb just fine with it down. Of course, once you're surely flying again in the go-around, retraction should be done in the normal manner - at this point, you're in a normal take-off. Finally, once everything is under control, acknowlege the tower's direction. Takes longer to read than it takes to execute. Dan Schaefer >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> LML website: http://www.olsusa.com/Users/Mkaye/maillist.html Builders' Bookstore: http://www.buildersbooks.com/lancair >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>