Return-Path: Received: from mtiwmhc03.worldnet.att.net ([204.127.131.38]) by truman.olsusa.com (Post.Office MTA v3.5.1 release 219 ID# 0-52269U2500L250S0V35) with ESMTP id com for ; Wed, 22 Sep 1999 20:10:21 -0400 Received: from ckrouse_ra.spk.hp.com ([12.73.163.160]) by mtiwmhc03.worldnet.att.net (InterMail v03.02.07.07 118-134) with SMTP id <19990923001413.JDWA29473@ckrouse_ra.spk.hp.com> for ; Thu, 23 Sep 1999 00:14:13 +0000 Message-ID: <000601bf0557$1aae7e00$a0a3490c@ckrouse_ra.spk.hp.com> Reply-To: "Curtis Krouse" From: "Curtis Krouse" To: Subject: Re: Wheel wells & Hyd. fluid Date: Wed, 22 Sep 1999 17:03:43 -0700 X-Mailing-List: lancair.list@olsusa.com Mime-Version: 1.0 <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> << Lancair Builders' Mail List >> <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> >> Are there any estimates as to how much weight it has added to your plane? I'm assuming that hydraulic fluid must weight between 5 or 6 lbs per gallon. I imagine that over the years one could gain quite a bit of unwanted weight from prepreg soakage. I plan on finishing the entire bottom of the belly pan and fuselage back to the forward wall of the aft bulkhead in the baggage compartment where I will install the power pack. Then all the way forward to at least the forward spar and out board to the BL 50 rib. Another note: aircraft hydraulic fluid is almost as bad for you as any cleaning agent that you can imagine. Your skin readily absorbs it and if you get it in your eyes, you might as well not plan on flying for quite awhile. I got some in my eyes (very little from film covering my hands) when I was in the service, and the result was swollen, pussy, pink eye for about 2 months. Another guy was on a drug known as antibuse for those sailors that couldn't control their drinking. He got one drop of hyd. fluid on his hand and it sent him to the hospital for a week. I guess hyd. fluid and antibuse don't mix...hehe. Curtis N753K >Prepreg seems to soak up Hyd Fluid and it is hard to get back out. Even >though polyurethane is hard to sand off, it is not nearly as difficult as >getting Hyd fluid out of prepreg. The area around the hyd. powerpack should >be finished with either polyurethane or at least painted with thinned >(acetone) epoxy. I didn't do this. >Bill N7WB >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> LML website: http://www.olsusa.com/Users/Mkaye/maillist.html