|
|
----- Original Message ----- From: "Dan Schaefer" <dfs155@adelphia.net>
snip
>My solution, though perhaps not the best though it's been fine
for over 800 hours, was to put small dimples in the flats of the nut and
after running it on as far as possible by hand, using a long punch and
tapping the dimples in the direction to tighten until it was tight.
snip snip
Hey that is known as "okie impact wrench!" You can also use a dull
cold chisel. Of course you have to smile after you say it or you can say "bless his heart." LOL
Gary "the okie" Melton
N320GG LNC2
|
|