Return-Path: <lancair.list-request@olsusa.com>
Received: from mtiwmhc03.worldnet.att.net ([204.127.131.38])
          by truman.olsusa.com (Post.Office MTA v3.5.1 release 219
          ID# 0-52269U2500L250S0V35) with ESMTP id com
          for <lancair.list@olsusa.com>; Sat, 7 Aug 1999 14:56:27 -0400
Received: from ckrouse_ra.spk.hp.com ([12.73.182.104])
          by mtiwmhc03.worldnet.att.net (InterMail v03.02.07.07 118-134)
          with SMTP id <19990807185953.JZXD12664@ckrouse_ra.spk.hp.com>
          for <lancair.list@olsusa.com>; Sat, 7 Aug 1999 18:59:53 +0000
Message-ID: <000901bee105$c59dece0$68b6490c@ckrouse_ra.spk.hp.com>
Reply-To: "Curtis Krouse" <ckrouse@worldnet.att.net>
From: "Curtis Krouse" <ckrouse@worldnet.att.net>
To: <lancair.list@olsusa.com>
Subject: Nose gear gas strut
Date: Sat, 7 Aug 1999 11:50:49 -0700
X-Mailing-List: lancair.list@olsusa.com
Mime-Version: 1.0

          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
          <<  Lancair Builders' Mail List  >>
          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> 
>>
Hey all,

I've got a question.  I'm getting ready to install the nose gear gas strut.
The instructions tell me to install the brackets so there is  3/8" distance
where the strut needs to be compressed to install it onto the drag link
assy.  Here's the question.  How do I compress the gas strut when I want to
attach it to the drag link?  This things got around 100lb pressure load on
it right?  For the life of me, I can't figure out how I'm going to compress
it to put it together with the drag link.  Any suggestions?

Curtis N753K


[Remove the pivot bolt from the middle of the over center links so the
drag link will rotate beyond its normal range of travel.  Attach the 
gas strut to the drag link and then raise the trailing o/c link back
into position.  You'll probably find it a bit difficult to raise that
trailing link into position and then align and reinstall the pivot bolt
if you try to do it manually, so I'd suggest using a little bottle jack
to raise it and compress the gas strut.  With the jack holding 
everything in the proper position, getting the pivot bolt back in and 
the o/c links back together should be a snap.  I hope this helps.

    <Marv>     ]

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML homepage:   http://www.olsusa.com/Users/Mkaye/maillist.html