Ed,

Thanx.  I had a 90 degree fitting welded up ready for a drill bit to size
it.  One less piece to the puzzle.

Barny
MGDQ 20bt

----- Original Message -----
From: Ed Anderson <eanderson@carolina.rr.com>
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Sunday, June 13, 2004 10:55 AM
Subject: [FlyRotary] Pressure Reduction Was Re: [FlyRotary] Re: SomeTaxi
testing today. With oil leak.


> Dave, a calculator I found on the Web indicated that with oil going from a
> 3/8" dia (AN-6) through a 1/8" orifice would reduce the pressure by approx
> 40 psi.  So if your engine is putting out 70-80 psi that would bring it
down
> to the 30-40psi range which should be acceptable.
>
> Ed
>
> Ed Anderson
> RV-6A N494BW Rotary Powered
> Matthews, NC
>
>
>
>
> >>  Homepage:  http://www.flyrotary.com/
> >>  Archive:   http://lancaironline.net/lists/flyrotary/List.html
>
>
> _____________________________________________________
> This message scanned for viruses by CoreComm
>