----- Original Message -----
From: "Bulent Aliev" <atlasyts@bellsouth.net>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Wednesday, May 26, 2004 9:02 PM
Subject: [FlyRotary] FW: [FlyRotary] Re: Fuel Injector Connectors


> Did you ever find electrical plugs to fit the stock injectors?  I was
always
> under the impression that you could get the plugs for the non-turbo
> injectors, but not for the turbo's.  As it turns out, the same plug fits
my
> turbo injectors, and the non-turbo injectors that you sent.  Damn odd, and
> very confusing.
>
> Rusty (haven't done crap on the intake in two days)
>
>
>
>
> The link below has MSD connectors available as an 8-connector kit for
> $12.60, which includes shipping.  They're an improvement over standard
> connectors in that the spring clip to remove the connector is easy to
remove
> with your fingers and won't come off (captured).  The kit includes:
>
> -       8 connectors, wire clips, and weather-tight seals
> -       20 female pin connectors
>
>
http://www.cprace.com/Merchant2/merchant.mvc?Screen=CTGY&Category_Code=MSDFU
> EL
>
> Go to the bottom of the page.  The last entry looks like this:
>
> EFI Injector Weather tight Connectors
> Code:MSD-2400
> Price:$12.60
>
> I received a set recently and the quality is as good or better than the
> Nissan wiring harness I bought a while back (the wire clips are much
easier
> to use), plus you can wire your Mil Spec wire directly to the pins.
>
> Happy connecting,
>
> Chris Sargent (way behind on starting my RV-7)
> Huntsville AL
>
>
> That is the exact same connector I received from Atkins Rotary.  I
agree....it is easy to remove, and has a nice, positive "snap" when it locks
onto the injector.  Paul Conner


----------------------------------------------------------------------------
----


> >>  Homepage:  http://www.flyrotary.com/
> >>  Archive:   http://lancaironline.net/lists/flyrotary/List.html
>