Congratulations Ed. Sounds like very good
progress. Now if I only had an RV-6 cowl...
As for the
measurements, I'd be happy to provide these, except that you lost me on
the descriptions of what you want. I'm attaching a couple pics
of the intake that I took while I was milling it. Can you
just mark on the picture where you want it measured? If you
can get the doctored pics back within about the next hour or so, I'll measure
this today at the hanger. If you're in a hurry for the numbers, email me
a phone number with the pics, and I'll give you a call from the
hanger.
Cheers,
Rusty
(attempting to finish what I planned to finish days
ago...)
Thanks, Rusty
I've marked on the photos the dimensions I am
interested in. I recognized that the throttle body side of the manifold
is at an angle, so it you would give me the measurement from the center rear
mounting bolt hole from both holes (as they will undoubtedly be different (or
were before they were machined {:>)) for that one.
Ed