|
Message
If anyone has one of the IDA "Webber" type
manifolds, I would appreciate it if you would provide me two measurements.
1. The vertical distance from the
block-mating surface of the manifold to the center of the opening of the
intakes of the manifold - looks like it might be 2-3 inches.
2. The distance from one of the rear center
block attachment bolt holes to the front surface of the front of the manifold -
should be on the order of 8-10 inches.
Thanks
Ed.
Congratulations Ed. Sounds like very good
progress. Now if I only had an RV-6 cowl...
As for the
measurements, I'd be happy to provide these, except that you lost me on the
descriptions of what you want. I'm attaching a couple pics
of the intake that I took while I was milling it. Can you
just mark on the picture where you want it measured? If you can
get the doctored pics back within about the next hour or so, I'll measure this
today at the hanger. If you're in a hurry for the numbers, email me a
phone number with the pics, and I'll give you a call from the
hanger.
Cheers,
Rusty
(attempting to finish what I planned to finish days
ago...)
|