|
Message
Oh, yea of little faith. You will need to
burp the engine a couple/three times to get all the air out of the cores.
But, by all means if your welding skills with very thin wall and brazed (lower
melting temp than aluminum) aluminum cores are up to the task then bleeds will
eliminate the need to do the burping runs. Good luck {:>).
Ed.
Ha! I laugh at thin, brazed aluminum cores,
hahaha! I managed to weld 10 fittings on 5 cores with no problems at
all, so I'll probably add the bleed fittings to make filling
easier.
Cheers,
Rusty (unfortunately .035" stainless butt welds are
laughing at me)
|