I
believe the things you have the arrows pointing to are triangular shaped braces
that support the oil sump to the oil pan. The are welded to top of sump
and plate.
To
access the bolts in the area of the sump, I stood the 4”x 4” tubing I used for
the sump off from the pan about 1 – 1 1/2”. I did this by using a 1” x 1
1/2” rectangular tube (its end’s plugged) welded to both the plate and the
sump. Then 3/4” dia (I think around 6 holes) holes were drilled
through plate, standoff and sump for the oil to return to the sump – probably
best to drill holes before welding components together, but they can be drilled
from the inside plate side – just make sure you get all shavings out. This
stand-off also gave you access to around 3-4 pan bolts. Depending on your
set up these may or may not be a pain to unscrew, but it can be
done.
The
round tall blue tube served as oil fill tube and dip stick tube. It was threaded
internally at the top and a threaded plug with a hole drilled in it for the dip
stick was used.
The
aluminum tubes were coolant (front) and air/oil separator (which I took off
after two years of flying with it and it collecting no oil, because the rotary
simply was not spitting any out.
Sent:
Tuesday, May 12, 2015 2:57 PM
Subject:
[FlyRotary] Questions for Ed Anderson- Plugs UP Oil
System
Ed,
I have a couple of question about
your plug up installation. How do you access the oil pan bolts located behind
the oil reservoir and allow for oil drain back? Also I see what looks like an
additional tube (black arrow) in the attached photo. Can’t figure out what it’s
for. Is it a support bracket?
Thanks,
Bobby Hughes
--
Homepage: http://www.flyrotary.com/
Archive and
UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html
No virus
found in this message.
Checked by AVG - www.avg.com
Version: 2015.0.5863 / Virus
Database: 4342/9756 - Release Date:
05/12/15