|
|
|
You can use the insert, however the B&C tool is adjustable. The mini's
for the garmin in addition to being less of a diameter are shorter. There is an
adjustment for this on the tool. However, before you make a crimp make sure that
the adjustment has not slipped. When shipped it the adjustment is defeated but
is easily changed..
Rich
In a message dated 6/2/2014 1:02:48 P.M. Central Daylight Time,
flyrotary@lancaironline.net writes:
from
b&c (Bob Nuckolls from the Aeroelectric
list):
http://www.bandc.biz/d-submachinedpincrimptool.aspx
from
Stein Air (great supplier for avionics, etc; active in RV
community):
http://www.steinair.com/storedetail.cfm?productid=291
Either
will accept a different tooling insert ($10) that will allow
crimping the
sub miniature pins used on some of the Garmin 430, etc
connectors.
If you have the skillset, it's a lot cheaper to just
use the solder cup
style connectors, but it is a *lot* more time
consuming.
Charlie
(currently burning holes in my
jeans....)
On 6/2/2014 12:48 PM, William Schertz wrote:
> I
purchased a crimp tool for D-sub pins from B&C for a lot less than 300$
(more like $40)
>
> Check B&C out
>
> Sent from my
iPad
>
> On Jun 2, 2014, at 11:59 AM, "Joseph Berki"
<flyrotary@lancaironline.net> wrote:
>
>> What is
everyone using for a 25 pin D connector? Are you using a crimp version
or solder version? The crimp tool for D connectors can be as much as
$300.00. Anyone have a less expensive solution? Thanks in advance
for any input.
>>
>> Joe Berki
>> Limo
EZ
>> --
>> Homepage:
http://www.flyrotary.com/
>> Archive and UnSub:
http://mail.lancaironline.net:81/lists/flyrotary/List.html
> --
>
Homepage: http://www.flyrotary.com/
> Archive and
UnSub:
http://mail.lancaironline.net:81/lists/flyrotary/List.html
--
Homepage:
http://www.flyrotary.com/
Archive and UnSub:
http://mail.lancaironline.net:81/lists/flyrotary/List.html
|
|