Bobby,
So that switches the EM-2 out of the
system and puts all the input to the 3.5mm jack. Is this because the
software must work without interference? Or does the software interfere with
the EM-2? I suppose the other end of the 3.5 mm plug is a USB plug?
Ok, I found the cable at Digikey. Should
this be the 5V or the 3.3V? Does it matter?
I hope you guys know what you are doing
putting all these ideas into my head! There will be questions!
Bill B
From: Rotary motors in aircraft
[mailto:flyrotary@lancaironline.net] On
Behalf Of Bobby J. Hughes
Sent: Thursday, January 24, 2013
7:15 PM
To: Rotary
motors in aircraft
Subject: [FlyRotary] Re: Hiccup!
I use a jack and
switch permanently installed to switch the serial signals between the EM3 and
Steve’s software.
Bobby
From: Rotary motors in aircraft
[mailto:flyrotary@lancaironline.net] On
Behalf Of Bill Bradburry
Sent: Thursday, January 24, 2013
5:39 PM
To: Rotary
motors in aircraft
Subject: [FlyRotary] Re: Hiccup!
Steve,
I am a pretty well defined dork when it
comes to herding electrons, but pins 16, 7, & 27 appear to be the ground,
in and out for the serial connection to the EM-2. So to make the
connection to the computer cable, I could tap these three wires and connect
them to the indicated computer cable wires and it would work? It appears
that the green and brown wires may be connected together as well?
I can get the computer cable where?
Radio Shack?
Bill B
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]
On Behalf Of Steven W. Boese
Sent: Thursday, January 24, 2013
5:46 PM
To: Rotary
motors in aircraft
Subject: [FlyRotary] Re: Hiccup!
Bill,
If you think the problem is with the EC2
signals, an example of examining those signals is shown in the following web
site:
www.rotarycopilot.com/
in the Start Up Sequence discussion in the
Documents section. Although this discussion dealt with an issue that has
since been resolved, the data collection and examination methodology may be
helpful for your situation. Using this would depend on being able to
collect data during the time that the problem occurred which might take
some effort if the problem doesn't happen very often.
It may also be worthwhile to consider setting
up the monitoring system described in the Software section of the same
website. This system was developed to troubleshoot my EC2
installation and enables one to verify the operation of the EC2 controls
(among other things). In my case, there was a cold solder joint on one of
the pins of the mixture control potentiometer of the control board resulting in
an intermittent connection. Watching the EC2 output as
the mixture control setting was changed made the problem obvious.
The engine didn't even need to be running to find the problem.
Let me know if you want more
details.
RV6A, 1986 13B NA, RD1A, EC2
Well the hiccup is much worse now!
In fact it is no longer a hiccup. I misses a string of 3-4 in a row and
loud backfires! It seems that it is electrical in nature as the mixture
was pretty well centered the whole time and turning the mixture knob
didn’t seem to help.
I am thinking about rewiring the entire
system, but I am somewhat concerned that I may just screw up something that is
not broken.
Didn’t there used to be someone on
the list that built wire harnesses for the EC-2?
Suggestions welcomed!
Bill B