Bill,
While I can understand why you might want
to hold this info close to the vest, you are going to have to be quite a bit
more forthcoming before you get any interest from me.
Bill
From: Rotary motors in
aircraft [mailto:flyrotary@lancaironline.net] On
Behalf Of William Mason
Sent: Sunday, September 30, 2012
12:35 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Complete
drawings for Intake mainfold...was xcessive LIM
Hello all,
I have been sitting on a complete set of plans drawings
that were given to me by a co-worker that in college had a thesis project on
the Mazda rotary engine for aviation use. Yeah... sounded too good to be
true to me as well.
Now I'm sitting on complete drawings, specs, dyno results from their project,
and all of their research. The dyno results show a comparison from
stock and some other configurations.
I can have it built as a one-off (read expensive) or I can make a run of these and
try to reduce the cost of my own copy by a few pennies. I can see a
possible need to change placement of the injectors to enable the assembly to
fit more applications, but the design is very nice. Commercial
interests will be welcome. Serious inquiries welcome. Casually
interested individuals please stand by for more information.
If you'd like to be placed on the list for a completed copy but don't want any
up-front cost, drop me a note.
Regards!
Bill