|
|
On 05/22/2012 04:29 PM, jskmberki@windstream.net wrote:
Monty and Charlie,
If you could measure the diameters that would be great.
Where did you find the tool with the counter bore?
Price?
Thanks for the input
Joe Berki
On Monday, May 21, 2012 7:40 PM, MONTY ROBERTS
<montyr2157@windstream.net> wrote:
>
They make a special cutting
tool with a counter bore on it for this job. I'm sure you can
accomplish the same thing with a drill, a counterbore, and a
couple reamers.
Monty
----- Original Message -----
Sent: Monday, May 21, 2012
7:37 PM
Subject: [FlyRotary] Re:
Drilling injector rail
>
On 05/21/2012 05:39 PM, jskmberki@windstream.net
wrote:
Does anyone know the sizes and configuration used to drill a fuel rail for RX8 injectors?
I think 7/16" will accommodate the first O ring.
Does there need to be a larger diameter to seat the second O ring which is different in shape? It is located close to where the electrical connector branches out.
Thanks for any help.
Joe Berki
--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html
I've got a factory pair of
rails. I can measure the diameter of the
injector cups for you tomorrow. If you can use them, I'd be
happy to let them go for whatever I paid (was pretty cheap on
ebay). This set is for 4 injectors: the 2 in the center housing
+ 2 on the intake manifold, complete with hoses.
>
> Charlie
>
>
>
Hi Joe,
I had a jammed up day today & didn't make it to the hangar.
My apologies; I promise it will be the 1st thing on my list when
I get home tomorrow.
Charlie
|
|