|
|
Bought something bigger, cut it down... filed the threads into a
taper at the tip and played with it carefully so it didnt cross
thread. Thats what I did with our first attempt at a block, when we
put an aluminum adapter on the oil pump pad for oil return and PSRU
feed.
Later gen used the stock oil return fitting with an AN adapter on
it.
On 12/8/2010 3:40 PM, Mark Steitle wrote:
Kelly,
Short story is that this is the tap size I had handy that fit
the hole. We're trying to plug the heater port on the rear
housing. Who would have thought that an 18mm x 2.0 would be an
oddball size! We found a place that sells 18mm x 2.0 nuts, but
they tell us that nobody makes an 18 x 2.0 bolt. That
seems hard to believe.
Mark
On Wed, Dec 8, 2010 at 3:26 PM, Kelly
Troyer <keltro@att.net>
wrote:
Mark,
Try the link below.............What in the world
is it for !!.................There may be other sources
but
this is the first one I found.................
Kelly Troyer
"DYKE DELTA JD2" (Eventually)
"13B ROTARY"_ Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil Manifold
"TURBONETICS"_TO4E50 Turbo
From:
Richard Sohn <res12@fairpoint.net>
To:
Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent:
Wed, December 8, 2010 2:57:49 PM
Subject:
[FlyRotary] Re: Source for 18mm x 2.0 Bolt
You will have a hard
time for that. M18 x 2.5 is standard and first
choice fine is 18 x 1.5 . You may have to get it
made.
Richard Sohn
N2071U
----- Original
Message -----
Sent:
Wednesday, December 08, 2010 1:49 PM
Subject:
[FlyRotary] Source for 18mm x 2.0 Bolt
Anyone know where I can purchase an 18mm x 2.0
bolt?
|
|