|
|
| Kelly,
You should have saved that fun-filled activity for Saturday night. ;-)
Mark On Wed, Dec 8, 2010 at 5:40 PM, Kelly Troyer <keltro@att.net> wrote:
Mark,
I went through the entire "Dorman" oil pan plugs selection online and found nothing in
2.0 thread pitch of any diameter..............
Kelly Troyer
"DYKE DELTA JD2" (Eventually)
"13B ROTARY"_ Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil Manifold
"TURBONETICS"_TO4E50 Turbo
From: Mark Steitle <msteitle@gmail.com>
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Wed, December 8, 2010 3:52:46 PM
Subject: [FlyRotary] Re: Source for 18mm x 2.0 Bolt
Good idea. Will do...
On Wed, Dec 8, 2010 at 3:47 PM, Kelly Troyer <keltro@att.net> wrote:
Mark,
18mm oil pan plugs (at any auto store) are readly available but if I remember
correctly they are 1.5 thread pitch (You might check this)............
Kelly Troyer
"DYKE DELTA JD2" (Eventually)
"13B ROTARY"_ Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil Manifold
"TURBONETICS"_TO4E50 Turbo
From: Mark Steitle <msteitle@gmail.com>
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Wed, December 8, 2010 3:40:29 PM
Subject: [FlyRotary] Re: Source for 18mm x 2.0 Bolt
Kelly,
Short story is that this is the tap size I had handy that fit the hole. We're trying to plug the heater port on the rear housing. Who would have thought that an 18mm x 2.0 would be an oddball size! We found a place that sells 18mm x 2.0 nuts, but they tell us that nobody makes an 18 x 2.0 bolt. That seems hard to believe.
Mark
On Wed, Dec 8, 2010 at 3:26 PM, Kelly Troyer <keltro@att.net> wrote:
Mark,
Try the link below.............What in the world is it for !!.................There may be other sources but
this is the first one I found.................
Kelly Troyer
"DYKE DELTA JD2" (Eventually)
"13B ROTARY"_ Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil Manifold
"TURBONETICS"_TO4E50 Turbo
From: Richard Sohn <res12@fairpoint.net>
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Wed, December 8, 2010 2:57:49 PM
Subject: [FlyRotary] Re: Source for 18mm x 2.0 Bolt
You will have a hard time for that. M18 x 2.5 is standard and first choice fine is 18 x 1.5 . You may have to get it made.
Richard Sohn
N2071U
----- Original Message -----
Sent: Wednesday, December 08, 2010 1:49 PM
Subject: [FlyRotary] Source for 18mm x 2.0 Bolt
Anyone know where I can purchase an 18mm x 2.0 bolt?
|
|