A lot of folks have nuts that can’t
screw…:>)
I am so sorry, forgive me, Jesus!
B2
From: Rotary motors in aircraft
[mailto:flyrotary@lancaironline.net] On
Behalf Of Mark Steitle
Sent: Wednesday, December 08, 2010
4:40 PM
To: Rotary
motors in aircraft
Subject: [FlyRotary] Re: Source
for 18mm x 2.0 Bolt
Short story is that this is the tap size I had handy that fit the
hole. We're trying to plug the heater port on the rear
housing. Who would have thought that an 18mm x
2.0 would be an oddball size! We found a place that sells 18mm
x 2.0 nuts, but they tell us that nobody makes an 18 x 2.0 bolt.
That seems hard to believe.
On Wed, Dec 8, 2010 at 3:26 PM, Kelly Troyer <keltro@att.net> wrote:
Try the link below.............What in the
world is it for !!.................There may be other sources but
this is the first one I found.................
Kelly
Troyer
"DYKE DELTA JD2" (Eventually)
"13B
ROTARY"_ Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil Manifold
"TURBONETICS"_TO4E50
Turbo
From: Richard
Sohn <res12@fairpoint.net>
To: Rotary
motors in aircraft <flyrotary@lancaironline.net>
Sent: Wed, December 8, 2010
2:57:49 PM
Subject: [FlyRotary] Re: Source
for 18mm x 2.0 Bolt
You will have a hard time for that. M18 x 2.5 is standard
and first choice fine is 18 x 1.5 . You may have to get it made.
----- Original Message -----
Sent: Wednesday,
December 08, 2010 1:49 PM
Subject: [FlyRotary] Source
for 18mm x 2.0 Bolt
Anyone know where I can purchase an 18mm x 2.0 bolt?