Return-Path: Received: from web41304.mail.yahoo.com ([66.218.93.53] verified) by logan.com (CommuniGate Pro SMTP 4.1.8) with SMTP id 2890678 for flyrotary@lancaironline.net; Sun, 14 Dec 2003 16:16:12 -0500 Message-ID: <20031214211607.26578.qmail@web41304.mail.yahoo.com> Received: from [65.102.119.99] by web41304.mail.yahoo.com via HTTP; Sun, 14 Dec 2003 13:16:07 PST Date: Sun, 14 Dec 2003 13:16:07 -0800 (PST) From: John Overman Subject: Re: [FlyRotary] SINGLE ROTOR To: Rotary motors in aircraft In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset=us-ascii --- Richard wrote: > > Another significant step for the next test series is > complete. The porting as shown in the picture. If > y'all remember, the P-P is in addition to one side > port. > I hope this partial S-C configuration results in > what I expect, meaning P-Port advantage at higher > RPM and still good idle stability at lower RPM > without a lot of additional mechanical gadgets. > > Attached is OMP adapter information. > > Richard Sohn > N-2071U > unicorn@gdsys.net > www.gdsys.net/WWWmembers/unicorn/ > I was thinking of using one of their metering pumps but decided instead just to use aeroshell 15W50 oil that I have had such good luck with in the past. Since it is ashless dispersant there should be little in the way of particle build up and if I run short, I can pick it up at any airport. still use the stock setup and not have to use two different kind of oils. John > ATTACHMENT part 2 image/jpeg name=RES12PP1E.JPG > ATTACHMENT part 3 image/jpeg name=RES12PP2E.JPG --------------------------------- PCV TECHNOLOGIES PCV TECHNOLOGIES Metering Pump Adapter for Wankel Engine. Description. Wankel engines such as the one used in the MAZDA RX7 sports car need oil in the combustion area for lubricating the metal seals. Most stock engines use a metering pump pumping a small amount of engine oil from the oil pan into the intake manifold and/or directly into the combustion chamber. Engine oil is designed to lubricate sleeve bearings and carry heat from the engine interior to some cooling areas. In the RX7 the heat is removed from the oil in an oil cooler. When engine oil is getting into the combustion chamber, it only is burning partially, leaving some unburned deposits behind. These deposits can build up and reduce engine performance. One obvious method of preventing this is to disconnect the metering pump altogether and mix two-stroke oil to the gasoline like some older two-stroke engines require. With this method it has been demonstrated that two-stroke oil is an effective lubricant and there is no build up of combustion residues. The Metering Pump Adapter, as offered by PCV Technologies takes the solution one step further in allowing to still using the stock metering pump but supply it with two-stroke oil. With the Adapter installed, all that is needed is a small oil tank with two-stroke oil, connected to the Metering Pump Adapter. The oil level in the tank should never be less then 6" above metering pump.Oil consumption is approximately 1/100 of fuel used. Ordering information on next page. __________________________________________________________________ 8029 HWY 1087, DeFuniak Springs, FL 32433. Tel/Fax(850)834-4905 email:unicorn@gdsys.net PCV TECHNOLOGIES Price: For 13B mech. Pump US$ 82.00 For 13B electronic Pump US$ 88.00 For 12A US$ 76.00 For 13B 3rd GEN mech Pump US$ 92.00 payable in check or money order to #9;Florida resident add 6% sales tax. PCV Technologies, INC. 8029 HWY 1087 DeFuniak Springs, FL 32433 All adapter configurations are in stock now. ____________________________________________________________________8029 HWY 1087, DeFuniak Springs, FL 32433. Tel/Fax(850)834-4905 email:unicorn@gdsys.net > >> Homepage: http://www.flyrotary.com/ > >> Archive: > http://lancaironline.net/lists/flyrotary/List.html > __________________________________ Do you Yahoo!? New Yahoo! Photos - easier uploading and sharing. http://photos.yahoo.com/