|
Keith,
Yes the 84-85 13B pan will fit........The two larger bolt holes for the engine mount on the
center housing are not drilled on the 84-84 13B pan but the small 6 mm bolt hole (Standard
pan bolts) is already drilled and threaded on your center housing (My 88 housing is) and will
match up with the early pan so there is no need to drill the pan for the larger bolts........One
other suggestion would be to make a spacer (stack of wide area washers ?) to fit in the space
between your existing pan and the CCI plate and go ahead and drill the plate for a bolt and
sealing washer..........Should not be a major problem IMHO.........
--
Kelly Troyer
"Dyke Delta"_13B ROTARY Engine
"RWS"_RD1C/EC2/EM2
"Mistral"_Backplate/Oil Manifold
-------------- Original message from ktradcliff@comcast.net: --------------
>
>
>
> If I can find one; Will a 1984 - 85 rx-7 stock oil pan fit the 1987 rx-7 block
> bolt for bolt with no modification?
>
>
>
>
> -------------- Original message ----------------------
> From: "Kelly Troyer"
> > Keith, > In an ideal situation you could find an 1984-5 RX7 13B pan that does not
> have
> > that > extra bolt hole in it as the mounts were still on the front
> cover...........But
> > since you
> > probably cannot find one I have a question.........Since I am not totally
> > familar with the
> > CCI mount plate is the spot on the plate under the extra oil pan bolt open or
> > would
> > you have to drill a hole for access to the threaded boss in the center housing
> > ?..........
> > I do not remember what the bolt size is (probably 12 or 14 mm) but if this
> > hole fits
> > flush with the CCI plate then a large headed bolt and copper gasket might seal
> > it !!
> >
> > FWIW
> > --
> > Kelly Troyer
> > "Dyke Delta"_13B ROTARY Engine
> > "RWS"_RD1C/EC2/EM2
> > "Mistral"_Backplate/Oil Manifold
> >
> >
> >
> >
> >
> > -------------- Original message from ktradcliff@comcast.net: --------------
> >
> >
> > > I am using the stock 13b oil pan along with the cci motor mount. The stock
> 13b
> > > oil pan has 3 motor mount holes that are utilized when mounted in the car.
> In
> > > aircraft application with the cci mount only two of the three bolt holes are
> > > used. I am looking for the best method to seal this extra hole. Are some
> > > choosing to weld this hole (although this is a very important piece to the
> bed
> > > mount and needs to maintain a good seal, and a bad weld may warp the thin
> > pan)?
> > > Or would a locking nut and bolt with some type of gasket maker do the trick?
> > > Possible some type of expandable plug like the ones used in a boats? Not
> sure
> > > what to do looking for the best answer.
> > >
> > > Thanks
> > > Keith
> > > RV-7A
> > > 13b
> > > With all of Tracy's stuff
> > > CCI Engine mount
> > >
> > > --
> > > Homepage: http://www.flyrotary.com/
> > > Archive and UnSub:
> http://mail.lancaironline.net:81/lists/flyrotary/List.html
>
>
|