|
Bob W, today I joined the non-start rotor
club, I expected it not to start after following the Saga of Buly and
Chris. We don't have any ignition. We checked the wires to the coils
and , all coil plugs have ground to block on pin A, ground to EC2 on pin B,
voltage on Pin D. On cranking, Pin C on the volt ohm meter on
cranking shows 9 volts, dropping to 7 volts which is a steady reading on not
pulsing. Pin B which is the
ground to the EC2, voltage rises to 27 volts. What
is the voltage that we should be seeing on pins B and C and should C show a
pushing voltage? Is the Tach interface that you sent me, which is
connected to EC2 pins 20 and 21 for leading coils having anything to do with the
fact that the coils are not firing. JohnD
|