|
I agree with Jason, I 've had the same ball joints for 10
years now. I did change the springs and hardware once during that
period. However, while they do great with lateral misalignment they by
themselves only provide limited longitudinal give (they can pull against the
springs and that provides some but not much-in my opinion). Having said
that, that is the only "slip" factor in my exhaust system, but apparently it is
enough. Recall though, my headers are made out of 0.10 stainless
Steel pipe rather than tube.
ED
----- Original Message -----
Sent: Friday, November 09, 2007 11:19
AM
Subject: [FlyRotary] Slip joint
Joe,
Slip joints turned out to be the
biggest issue with my exhaust system. I finally broke down and ordered a ball
joint assembly.
Jason
Hutchison
"This e-mail may contain
confidential and/or legally proprietary material for the sole use of the
intended recipient. Any review or distribution by others is strictly
prohibited. If you are not the intended recipient, please contact the
sender and delete all
copies."
|
|