I'd drill out the JB weld and tap the hole for a 3/8 NPT. A
5/8" hose barb fitting will go there nicely. I did this on my 4 port 2nd
gen engine. This is where you FEED water from, not return since this is
the highest pressure hot water port in the system. Return should be to the
water pump inlet.
----- Original Message -----
Sent: Wednesday, November 15, 2006 8:21
PM
Subject: [FlyRotary] "Front" Housing (on
car) question
I am looking for spots to pick up and return water (for my
heater core) from one of the housings. I noticed a plug on the
"front" housing across from the plugs so I was wondering
if that would be a good spot to pull or return water from?
The normal heater core feed on my "rear" housing (under the oil
filter) appears to be unusable for this purpose due to being filled with
JB weld, etc.; so I don't think I can take water from there.
Thanks for your comments.
Doug