Received-SPF: pass
 receiver=logan.com; client-ip=65.54.246.75; envelope-from=thomphy@msn.com
Message-ID: <BAY118-DAV3A51FCE2744708A6CCE93BAFA0@phx.gbl>
From: "Thomas Phy" <thomphy@msn.com>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
References: <list-1515416@logan.com>
Subject: Re: [FlyRotary] Re: Prewired EC2 Cables
Date: Mon, 30 Oct 2006 15:52:24 -0800
MIME-Version: 1.0
Content-Type: text/plain;
	charset="iso-8859-1"
Content-Transfer-Encoding: 7bit

Me to. The RV-? crowd should be a no brainier.
TP
RV-7
----- Original Message ----- 
From: "Bob Tilley" <btilley@mchsi.com>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Monday, October 30, 2006 3:11 PM
Subject: [FlyRotary] Re: Prewired EC2 Cables


> Bob,
> 
> I would like to get a wiring harness!  Tracy's EC2, LS1 coils, long  
> wiring length. What other info do you need? I'm installing it in a  
> Cozy MK IV.
> 
> Bob Tilley
> 802 Beechwood Dr
> Albany, Ga 31721
> 
> 
> On May 26, 2005, at 12:27 AM, Bob White wrote:
> 
> > I'm contemplating offering prewired cables for Tracy's EC2.  I've been
> > in the electronics field for over 40 years so soldering and cabling  
> > are
> > easy for me.
> >
> > I would prewire the 15 and 37 pin connectors to your specified length.
> > Other wires would be long enough to be cut off and terminated by you.
> > Wires would be tefzel (M22759/16) or better and each wire would be
> > clearly marked.  Everything would be done to the specs in Tracy's
> > manual.
> >
> > Using my installation as a reference, I would make the unterminated
> > wires that go under the insturment panel 5 feet long and those  
> > going to
> > the engine compartment 10 feet long.  Length from the 15 pin
> > connector to the 37 pin connector is 36 inches.  Based on that, the  
> > cost
> > would be $95 but this would be adjusted for different lenght
> > requirements. These lengths should leave enough wire for most
> > installations.
> >
> > Also, for the canard community, I would be willing to cable  
> > anything up
> > to your specifications, but because of the long runs and  
> > sensitivity to
> > noise I wouldn't want to gurantee sucess in using the cable.
> >
> > Is there any interest in such a service?
> >
> > Bob White
> >
> > -- 
> > http://www.bob-white.com
> > N93BD - Rotary Powered BD-4 (real soon)
> >
> >>>  Homepage:  http://www.flyrotary.com/
> >>>  Archive:   http://lancaironline.net/lists/flyrotary/List.html
> >
> 
> 
> --
> Homepage:  http://www.flyrotary.com/
> Archive and UnSub:   http://mail.lancaironline.net/lists/flyrotary/
>