|
The Haynes manual shows a oil level sensor
and temperature sensor located in the pan. The pan I have, has only the
sensor which is held in by a 3 bolt flange, which sensor is this. I can
not remove this without removing the engine, so if it is a temp sensor, I assume
it probably isn't compatible with my gauge. Where are you fellows picking
up your oil temperature from. The worst case scenario, I can screw the 14
x 1.5 mm adapter from JC Whitney in the oil plug hole and install the temp
sensor in that. I have the water temp sensor and the oil pressure
sensors installed in the holes under the oil filter as in the stock auto
installation.
One other question. On the back of the
gauges, it appears that the power input posts are marked with an I, does mean
power in or does it have another meaning. JohnD
|