-------------- Original message from Bob White <rlwhite@comcast.net>: --------------


> Hi Kelly,
>
> To minimize the amount of stuff I need to keep on hand, I supply all
> EC2 cables with the three wire shielded cable. For the Renesis sensor,
> one wire is not used. The shield is grounded at the EC2 per Tracy's
> instructions.
>
> Bob W.
>
> On Thu, 29 Dec 2005 16:36:54 +0000
> keltro@att.net (Kelly Troyer) wrote:
>
> > To Bob White,
> > Bob is the lead for the ignition sensor shielded ? Since the Renesis
> sensor
> > only requires two conductors instead of three for the RX-7 sensor can you
> > provide the two conductor lead for a Renesis EC-2 cable ? Also is the shield
> > for this lead routed to ground at the EC-2 as is common practice ?
> > --
> > Kelly Troyer
> > Dyke Delta/13B/RD1C/EC2
>
>
> --
> http://www.bob-white.com
> N93BD - Rotary Powered BD-4 (Projected engine start - maybe next week)
> Custom Cables for your rotary installation -
> http://www.roblinphoto.com/shop/
>
> --
> Homepage: http://www.flyrotary.com/
> Archive and UnSub: http://mail.lancaironline.net/lists/flyrotary/