Hi Kelly,

To minimize the amount of stuff I need to keep on hand, I supply all
EC2 cables with the three wire shielded cable. For the Renesis sensor,
one wire is not used.  The shield is grounded at the EC2 per Tracy's
instructions.

Bob W.

On Thu, 29 Dec 2005 16:36:54 +0000
keltro@att.net (Kelly Troyer) wrote:

> To Bob White,
>       Bob is the lead for the ignition sensor shielded ? Since the Renesis sensor
> only requires two conductors instead of three for the RX-7 sensor can you
> provide the two conductor lead for a Renesis EC-2 cable ? Also is the shield
> for this lead routed to ground at the EC-2 as is common practice ?
> --
> Kelly Troyer
> Dyke Delta/13B/RD1C/EC2


--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (Projected engine start - maybe next week)
Custom Cables for your rotary installation -
http://www.roblinphoto.com/shop/