|
Message
I just found a tach locally that "should" work, if
you're willing to use the inductive pickup that comes with it. You'll be
happy to know that it's 3 -
3/8" round as well. According to the online manual, it's fully
programmable for 1,2,3,4,5,6,8,10,and 12 cylinders, so I think we're
covered. If I have any more trouble with my Tiny Tach, I'll be heading
down to the store to pick one of these up.
I bought one of
these, and got a chance to test it briefly today. I just had to see
if it would work with the LS-1 coil trigger signal, and amazingly,
it does! I didn't run the engine over about 2500 rpm, so
this wasn't a full test, but I'm pretty optimistic at this point. I just
set the tach to "2 cylinder", and it reads correctly. Sure hope
it does the same at high rpm.
Rusty
|