Tracy,
Since I’m wiring the EC-2
connector tomorrow, can you verify what wires I need to make available for
connection to the EM-2? There’s one pin labeled serial out to future
engine monitor. Is that the only wire I need? How about the EIS
tach wire, or the one that says it goes to the future fuel flow instrument (O2
sensor)? Are any of the previously unused pins used now?
Thanks, particularly if you can
answer it before I actually wire up the connector :-)
Rusty
Turbo 13B powered RV-3
(experimental aircraft)...Be Afraid :-)
1993 RX-7 R1... Not stock, carry
bail money :-)