|
Kelly.
I picked-up a second hand set of pulley, timing wheel and pick-up for $100
Aust - new cost was about $170 for Pulley/Timing wheel and $93 Aust for pick-up.
Mine was off a Mazda demonstrator engine and didn't have much use.
The timing wheel is attached to the pulley by bolts
through the pulley. I don't know why you have to buy them together! I will know
more when I get them.
But the way to go, I believe
George (down under)
Yes.
Tracy
----- Original Message -----
Sent: Tuesday, April 05, 2005 12:16
PM
Subject: [FlyRotary] Re: Timing
Tracy,
Can the RX-8 Crank sensor option be retrofit to
existing EC-2's ?
--
Kelly Troyer
Dyke
Delta/13B/RD1C/EC2
--------------
Original message from "Tracy Crook" <lors01@msn.com>: --------------
Assuming you have no problems mounting the wheel & sensor in the
same relative position they are on the RX-8 engine, it will work fine on
any rotary (1,2, 0r 3 rotors). You must order EC2 with the RX-8
crank sensor option for this to work of course.
Tracy (preparing for road to go under water again)
Tracy,
Can the RX8 timing wheel and sensor be used
on the RX7 and can I use it on the single without causing other problems
- using your EMS.
George ( down
under)
|